Powertap SLC+ User Guide Manual de usuario descargar pdf (Pagina 39)

4 - Standard Test File

This mode writes a small test file to the memory. Press [SELECT] and the bottom lines says

“run” and then “yes” when the file is written. This file can then be downloaded.

5 - Communication Loop Back Test

When looking at the front side of the computer, use a coin or paper clip to short out the two

pins on the left side. Press [SELECT]. The bottom line will say “run” and then “yes” if it passes

the test correctly. If the pins are not shorted together or there was a problem, the display will

say “no”. This test can be repeated by pressing [SELECT].

6 - Fast Memory Test

This tests the memory in the computer. Press [SELECT] and “run” is displayed on the bottom

line. When the test is completed and it passes, it says “yes”. If the test should fail, the bottom

line will say “no”.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44

Sin comentarios

Powertap SLC+ User Guide Manual de usuario Pagina 39